Starting Operation

A very large rechargeable battery will prevent the battery cover (5) from closing. In this case, the battery cover can be removed.

Push the two hinges inwards against the spring force. Remove the battery cover. There is no IP protection whilst the battery cover is not in place!

To refit the battery cover, push the two hinges inwards against the spring force again. Place the battery cover on the housing. Allow the two hinge pins to engage in the openings on the housing.

Place the cordless worklight on a stable, level surface. Make sure it is secure.

The notched carrying handle (3) can be used to hang up the cordless worklight. Make sure it is hung up securely.

You can use the tripod mount (4) to screw the cordless worklight onto a tripod.

Tighten the 1/4" screw. Ensure that the tripod has a firm footing.

On/off switch

Function

Press once

Switches on the cordless worklight, dimmed

Press twice

Switches on the cordless worklight, full brightness

Press three times

Switches off the cordless worklight

If the cordless worklight has been switched on in dimmed mode for approx. five minutes, it will be switched off immediately the next time the button is pressed.

When the permitted operating temperature is exceeded, the cordless worklight initially reduces the brightness before switching itself off if required for protection. Let the cordless worklight cool down and then switch the cordless worklight back on.

  • Make sure that the battery compartment (9) is not damaged when removing the coin cell.
  • Make sure that the positive pole of the coin cell faces upwards.

A warning will be displayed in the app before the coin cell (10) is fully used up.

To change the coin cell (10), unlock the locking mechanism of the battery cover (6) and fold back the battery cover (5).

Unscrew the screw of the battery compartment cover (12) and remove the battery compartment cover (11).

Remove the empty coin cell and insert a new coin cell.

Reattach the battery compartment cover with the screw.